38
V60T/July 2020/V1.1
To adjust the slide
1)
Lower the slide to its lowest point
2)
Adjust each of the 5x screws, in turn as below.
3)
Refer to [image 20]. Release the locknut with an 8mm spanner.
4)
Adjust (tighten) the socket set screw with a 2.5mm Allen key.
5)
Check the slide movement and keep readjusting until there is a slight resistance.
6)
When happy with the adjustment lock the socket set screw by tightening the locknut with
the 8mm spanner.
7)
Check the slide movement.
After adjustment the slide should be easy to move up and down, it should also stay at any height
position. Do not overtighten the adjustment screws!
REPAIR, MODIFICATION AND INSPECTION
Repair, modification and inspection of HMT Magnetic drilling machines must be done by HMT or
HMT authorized dealer. The spare parts list will be helpful if presented with the machine to the HMT
dealer for service when requesting repair or other maintenance.
HMT machines are constantly being improved and modified to incorporate the latest technological
advancements. Accordingly, some parts (i.e. part numbers and/or design) may be changed without
prior notice. Also, due to HMT
’
s continuing program of research and development, the specifications
of machines are subject to change without prior notice.
WARNING:
Since accessories, other than those offered by HMT, have not been tested with this
product, use of such accessories with this tool could be hazardous.
To reduce the risk of injury, only HMT recommended accessories should be used with this product.
Consult your dealer for further information on the appropriate accessories.
