15
V60T/July 2020/V1.1
4.1.2
M
ounting the drill guard
The drill guard protects against ejection of sharp and/or hot chippings, it also protects against
accidental contact with rotating parts and must always ALWAYS be mounted during operation.
1)
Ensure the drill mounting bracket (1) is attached to the motor lower support and is secure.
2)
Slide the drill guard (2) up to the bracket.
3)
Fit the 6mm shoulder screw (4) with a nylon washer (3) between it and the face of the guard.
4)
Fit M6 thumbwheel (5) with an M6 spring washer (6) and nylon washer to the guard face.
5)
Tighten the shoulder screw and then adjust the thumbwheel to allow the guard to just slide.
6)
The guard can be locked in position at any time using the thumbwheel.
[image 5]
