Step 3 – Landing Gear Installation
Building Note:
It is recommended but not required to use landing gear
dampeners. If so you will have to acquire them and the necessary hardware from
your Quick-worldwide dealer.
Locate and drill two holes 3mm in
diameter spaced and 92mm center
to center. Note: make Sure the
holes are centered on the struts.
Mount the Struts to the frame rails
using (4) M3-18 Cap Head Bolts.
Slide the Skid pipes thru the Struts
till you center them to allow
adequate support for the
helicopter. Fasten the Struts to the
skid pipes using (4) M3-3 Set
Screws.
