Build the Boom supports
using (4) Boom Support
ends, (2) Boom Support
Rods, & (4) M2-12 Cap
Head Bolts. The ends
should be parallel to each
other and drill a 2mm hole
for the retaining bolts to go
through and apply a little
CA to each end while
bolting them together.
Attach each of the boom
supports to the rear lower
frames in any of the 3
holes provided using (2)
M3-10 Cap Head Bolts &
(2) M3 Locknuts
Attach both boom supports
to the vertical fin mount
using a (1) M3-18 Cap
Head Bolt & (1) M3
Locknut The fin should be
perpendicular to the
frames.
