Step 2 – Linkage Rod Setup
In the following table the linkages will
be measured center to center as per
the picture. The table explains the
amount of rods you need to make and
which ball links to use on each end.
This will get the helicopter close to
finished setup, as always you will need
to make some final adjustments to
maximize the performance of you
Rod Use
Throttle Servo to Carburetor
Linkage ID Letter
A
# of Rods
1
Rod Size
2.3-90
Ball Link 1
Long
Ball Link 2
Long
Center to Center
110mm
Rod Use
Rear Lower Swash Servo to T-Lever
Linkage ID Letter
B
# of Rods
2
Rod Size
2.3-35
Ball Link 1
Long
Ball Link 2
Long
Center to Center
57.6mm
Rod Use
Rear Upper Swash Servo to T-Lever
Linkage ID Letter
C
# of Rods
2
Rod Size
2.3-35
Ball Link 1
Long
Ball Link 2
Long
Center to Center
57.6mm
