Rod Use
Rudder Servo to Tail Pitch Change Lever
Linkage ID Letter
L
# of Rods
1
Rod Size
Carbon Rod
Ball Link 1
Long
Ball Link 2
Long
Center to Center
768.35mm
Rod Use
Tail Pitch Slider to Tail Rotor Assm.
Linkage ID Letter
Pitch-slider
# of Rods
NA
Rod Size
NA
Ball Link 1
Med
Ball Link 2
Med
Center to Center
NA
Step 2A – Additional Setup Information
Tail Blade Holder Setup
Using (2) M2-10 Phillips Screws, (2) Shim Balls, (2) M2 Nuts attach the shim
balls to the tail blade grips.
Servo Arm Hardware
The remaining (9) Shim Balls & (9) M2-7 Phillips Screws are used on the servo
arms.
Tail Rudder Push Rod Hardware
Construct the Rudder push rod with (2) Machined Carbon Push Rod Ends & (1)
Carbon push rod cut the rod to length and epoxies the ends on finish with (2)
Long Ball Links. Use the (3) Tail Control Rod Guides, (3) Tail Control Rod
Guides inserts, & (3) Tail Control Rod Guides inserts B. The three tail control rod
guides are epoxies together to make complete assemblies. Space the
assemblies evenly about the boom and use CA Glue to attach them.
