Set the gear mesh between the
rear tail transmissions using a
double thick piece of notebook
paper. Place the paper between
the counter gear and the main
gear. Loosen the eight bolts that
fasten the transmission to the
frames and rotate the paper
between the gears press the gears
together firmly and retighten the
bolts and remove paper check for
smooth operation of the gears
readjust if necessary.
Step 3 – Clutch Bell Installation
Install the clutch lining in the
Clutch bell using JB weld. The
Clutch lining may have to cut to a
length of 145mm. Note: Be sure
not to over apply the JB Weld be
sure that you clutch lining is
smooth when the installation is
complete.
Install the clutch bell into the
start shaft-bearing block.
