Hobbies & Helis Gas-Her, Instruction Manual

Page: 83 / 104

Page 83 of 104
8-2B LINKAGE ASSEMBLY PRO VERSION
There are two types of linkage rods you will construct:
•
Regular linkage rod: constructed by two ball ends and one metal rod.
•
Carbon linkage rod: constructed by two ball ends, two rod ends, one carbon rod, and
CA glue. This carbon rod should be cut to specific length. In some cases, rod ends
should be cut to specific length as well. We will tell you how to cut them and how long
you need.
No. Bag# Description Qty
1 8 2.3 Long Ball End 22
2 8 2.3 Medium Ball 10
3
8
2.3 Short Ball End 4
4 8 2.3x10mm Rod 2
5 8 2.3x20mm Rod 2
6 8 2.3x25mm Rod 2
7 8 2.5mm Rod End 24
8 In box 2.5mm Carbon Rod 3
9***** CA glue 1
Rod Assembly:
All the Linkages should be assembled with dimensions measured center to center as following:
No. Bag # Rod Description Ball Ends Used Rod Ends Center to Center Qty
1 2.3x10mm Rod Short Ball End 25 mm 2
2 2.3x20mm Rod Long Ball End 46 mm 2
3 2.3x25mm Rod Long Ball End 54 mm 2
4 2.5x25mm Carbon Rod Medium Ball End Cut to 12mm (both sides) 68 mm 4
5 2.5x28mm Carbon Rod Medium Ball End Cut to 12mm (both sides) 71 mm 1
6 2.5x43mm Carbon Rod Long Ball End Full length 97 mm 2
7 2.5x70mm Carbon Rod Long Ball End Full length 124 mm 3
8 2.5x90mm Carbon Rod Long Ball End Full length 144 mm 2
9***** Single Servo Arm 1
10***** Double Servo Arm 3
11 HB Shim Ball 7
12 HB M2x8 Phillips Screw 7
13***** M3 Servo Phillips Screw 4
It is recommended to cut a carbon rod and rod end by electronic cutter like Dremel
®
with
thin carbide cut-off wheel but the others may work too. Do not cut it by a scissors, pliers, or
wire cutter. Note: The lengths of Linkages are used for reference only. Final adjustments
will be needed when you do radio setup.