Hobbies & Helis Gas-Her, Instruction Manual

Page: 22 / 104

1-8 RIGHT SIDE ASSEMBLY
No. Bag# Description Qty
1 Step 1-7 Right Upper Frame Subassembly 1
2 1 Long Canopy Standoff (40mm) 1
3 1 M3x26 Cross Member 3
4 Frame Bulkhead 1
5 1 Clutch Bearing Block Assembly 1
6 Step 1-5 Tail Transmission Assembly 1
7 1 Lower Main Shaft Bearing Block 1
8 1 10x24x9 Thrust Bearing 1
9 HB M3x8 Cap Head Bolt 14
10 1 Upper Main Shaft Bearing Block 1
11 HB M4x10 Cap Head Bolt 2
12 HB M3x7 Flat Washer 6
Note: Put six M3x7 Flat Washers between the frame and screws when installing Clutch
Bearing Block and Tail Transmission. It is recommended to use M3 Nord-Lock Washer
for Clutch Bearing Block for stronger holding. If so, use M3x10 Cap Head Bolts instead
of M3x8 Cap Head Bolts. See the following drawing. For the Clutch Bearing Block, the
side with the smaller bearing should be face up.
Page 22 of 104