Hobbies & Helis Gas-Her, Instruction Manual

Page: 27 / 104

1-10 CLUTCH BELL ASSEMBLY
No. Bag# Description Qty
1 1 Pinion Gear* 1
2 1 Clutch Bell 1
3 1 Clutch Shoe Lining 1
4 HB M4x4 Set Screw 1
5 1 Start Coupler 1
6 1 Start Shaft 1
7***** Electronic Tape 1
*The thread portions of some Pinion
Gears are a bit too long. This will
make pinion touch clutch bell bearing.
In this case, just sand down the
thread portion a little to ensure the
pinion does not touch the clutch bell
bearing.
Install (1) Clutch Lining into (1) Clutch Bell. Note: The recommended adhesives for installing
the clutch lining are JB Weld or 10 Min + Epoxy. Prepare the clutch bell by scuffing the interior
with an x-acto blade or sand paper. Put the Clutch Lining in the Clutch Bell and mark it for
cutting (the length is around 143mm). Cut the Clutch Lining. Apply the adhesive thin and even
and finish the installation by inserting and finishing the clutch lining. Trick: Use electric tape
wrap around the Clutch Shoe (in bag # 2) one time. Then insert the Clutch Shoe into the
Clutch Bell. Clean up any excess adhesive. Let it sit there until the adhesive dry out then take
the Clutch Shoe off. Check label on the adhesive bottle for drying time.
Page 27 of 104