Hobbies & Helis Gas-Her, Instruction Manual

Page: 55 / 104

5-2 TAIL ROTOR ASSEMBLY
No Bag# Description Qty No. Bag# Description Qty
1 Frame Tail Case Side Plate 2 13 HB M3x5x1 Spacer 1
2 5 Tail Pitch Lever Mount 1 14 HB M3x16 Cap Head Bolt 1
3 5 5X10X4Flange Bearing 2 15 HB M3 Locknut 2
4 HB M2x6 Phillips Screw 2 16 Step 5-1 Tail Pulley Gear Subassy 1
5 In box Tail Boom (in Box) 1 17 HB M3x7 Pivot Ball Stud 1
6 In box Timing Belt (in Box) 1 18 HB M3x7 Flat Washer 1
7 HB M3x6 Cap Head Bolt 6 19 HB M3x25 Cap Head Bolt 1
8 5 Tail Case Cross Member 1 20 5 Tail Idler 1
9 HB M3x4 Pivot Ball Stud 1 21 5 3x6x5.5 Spacer 2
10 8 M2.3 Long Ball Link* 2 22 5 2.3mm Spherical Link** 2
11 5 Tail Pitch Slider 1 23 HB M2.5x6 Cap Head Bolt 1
12 5 Tail Pitch Control Lever 1
*Sport version only
**Pro version only
First, to prevent the Boom
End from rotating, drill a
2.3mm hole on a side of the
Boom End, then secure with
an M2.5x6 Cap Head Bolt.
Install the Bearings into the
Tail Case Side Plates. The
flanges should be inside.
Sometimes, the holes are too
tight; you have to sand them
a little bit.
Page 55 of 104