SECTION 7A: ROTOR HEAD
SPORT VERSION
Bag 7
7A-1 MAIN ROTOR HUB ASSEMBLY
No.
Bag# Description Qty
No.
Bag# Description Qty
1 7 Main Blade Grip
2
9
HB
M3X5X3 Spacer
2
2
7
Pitch Arm
2
10
7
Head Spindle Spacer
2
3 7 Center
Hub
1 11 7 Thrust
Bearing
Spacer
2
4
7
Hiller Arm
2
12
7
8x16x5 Thrust Bearing
2
5
7
Head Spindle
1
13
7
M4 Flange Cap Head Bolt
2
6 7 Dampener
O-Ring
4
14
7
8x16x5 Regular Bearing
4
7 HB
M3x7 Pivot Ball Stud(*)
2
15
HB
M3x12 Cap Head Bolt(*)
2
8 HB
M3x10 Cap Head Bolt
4
(*) or four M3x4 Pivot Ball Studs; two M3x14 Cap Head Bolts.
Note: Some Center Hubs are designed for one O-ring each side. If this is your case, use
one O-ring each side. The beveled edge of the Thrust Bearing Spacer (No. 11) should
be face away from the Center Hub. The flanges of the bearings of the Hiller Arms should
face outside. Usually the Thrust Bearing has three parts: two race washers and caged
ball bearings. The caged ball bearings will be between two race washers. In some cases,
you may get different version of the Thrust Bearing: one race washer, one flat washer,
and caged ball bearings in your kit. That is fine; it still works the same. In this case, you
need to install the flat washer first (next to Thrust Bearing Spacer-No. 11), then the
caged ball bearings, the race washer goes last.
Page 67 of 104
Summary of Contents for Gas-Her
