HNF-NICOLAI UD1 PedelecW, Manual

Page: 114 / 120

114
8.1. Turning the handlebar
It may be necessary to turn the handlebar during transport. In order to do so, pro-
ceed as follows:
• Loosen both red marked screws on the stem
with a suitable Allen key.
• Turn the stem into the desired position.
• If you wish to transport the bike without a
cyclist, it is sufficient to firmly both screws.
• If you wish to restore the UD1 to its riding position, tighten the side crews with
14-15 Nm.
8.2. Installing/removing the pedals
The right pedal has a right-hand thread and the left pedal has a left-hand
thread on the pedal axle. The right pedal is screwed clockwise and the left
pedal is screwed anticlockwise.
• For installation, proceed as follows:
• Grease the thread of the pedal axle and the crank sparingly. First screw the
pedal in loosely by hand. Make sure that you place the parts at the correct
angle to each other and do not tilt them.
• Put the crank in a horizontal position so that
the right pedal points towards the front
wheel.
• Tighten the pedal with a suitable Allen key to
30-35 Nm.
Transporting on a car