Assembly Instruction
Motor Interface Design
Torque Motor
TM-Komponenten-04-0-EN-2108-MA
Page 42 of 84
4.3
Stator interface design
The recommended tolerance of housing’s inside diameter and stator’s mounting holes is H7 or H8, and the
recommended flatness specification of stator mounting level (Flatness B) is given in Table 4.7. Housing is
suggested to be chamfered, deburred and rounded (the recommended dimension is shown in Fig. 4.9) to avoid
scratching O-ring and causing water leaking.
Fig. 4.8: Stator mounting interface
Fig. 4.9: Housing mounting interface
