Assembly Instruction
Introduction
Torque Motor
TM-Komponenten-04-0-EN-2108-MA
Page 13 of 84
nicht verwenden
Put the motor in the oven, set the temperature to 70
℃
(the maximum temperature
should not exceed 80
℃
), take it out after four hours, and put it at room temperature.
nicht verwenden
Measure the insulation resistance, if it does not reach 100
M
Ω
, repeat the process i (at
this time, pay attention to whether the insulation resistance has gradually increased, if it cannot be
improved, please contact HIWIN).
Table 1.4: Storage conditions
Environmental parameter
Unit
Value
Air temperature
(
℃
)
-5 ~ 40
Relative humidity
(%)
5 ~ 85
Absolute humidity
(g/m
3
)
1 ~ 25
Rate of change of temperature
(
℃
/min)
0,5
Air pressure
(kPa)
70 ~ 106
Solar radiation
(w/m
2
)
700
Condensation
Not allowed
Formation of ice
Not allowed
Long-term storage conditions
Refer Class 1K3
Store the motor in an environment with good weather protection. (indoor/factory)
Biological conditions
Class 1B1
Chemically active substances
Class 1C1
Mechanically active substances
Class 1S2
Mechanical conditions
Class 1M2
1.3.11
Transport precautions
1
Permanent magnets are listed as Dangerous Goods (Magnetized material: UN2807) according to
International Air Transport Association (IATA).
2
For products containing permanent magnets, no additional measures on packaging are required to resist the
magnetic field in sea freight and inland transportation.
3
When transporting products containing permanent magnets by air, the maximum permissible magnetic field
strengths specified by the appropriate IATA Packing Instruction must not be exceeded. Special measures
may be required so that these products can be shipped. Above a certain magnetic field strength, such
shipments must be labelled in accordance with Packing Instruction 953 from IATA (Please refer below or the
latest regulation from IATA.)
nicht verwenden
Products whose highest field strength exceeds 0,418 A/m (0,525
μ
T
) or 2° of compass
deviation, as determined at a distance of 4,6 m from the product, require shipping authorization from the
responsible national body of the country from where the product is being shipped (country of origin) and
the country where the airfreight company is based. Special measures need to be taken to enable the
product to be shipped.
nicht verwenden
When shipping products whose highest field strength is equal to or greater than 0.418
A/m (0,525
μ
T
) or 2° of compass deviation, as determined at a distance of 2,1 m from the product,
shipment is conducted with regulation of Dangerous Goods Transportation.
nicht verwenden
When shipping products whose highest field strength is less than 0.418 A/m (0,525
μ
T
),
as determined at a distance of 2,1 m from the product, you do not have to notify the relevant authorities
and you do not have to label the product.
4
Shipping originally packed motor components neither has to be disclosed nor marked.
5
Transport conditions must comply with EN 60721-3-2 (Please refer Table 1.5).
