SSB2
CCI command
Cause of error
9707
paircreate
You cannot create the HTI pair because the capacity of the pair
that you are trying to create exceeds the amount of licensed
capacity you have reserved.
9718
All commands
The command ended abnormally. You tried to use a command
other than
paircreate
for the volume in the pair other than the
HTI pair.
This error can also occur if you run the command with an
unsupported parameter specified.
9719
All commands
The command ended abnormally because the pair is in a status
that the command does not accept.
This error can also be reported if you run the command with an
unsupported parameter specified.
971A
paircreate
You cannot create the HTI pair because you do not have sufficient
SM capacity.
971F
pairresync -restore
You cannot restore the HTI pair because the volume you specified
as the P-VOL has an S-VOL Disable attribute.
9722
paircreate, pairsplit,
pairresync,
pairresync -restore
The command ended abnormally because you specified either of
the following for the HTI P-VOL.
•
External volume for which the Data Direct Mapping attribute is
enabled.
•
Volume belongs to a parity group for which accelerated
compression is enabled
These volumes can only be used as the pool volume.
9723
All commands
VSP G200: The command ended abnormally because shared
memory (Base) is not added.
VSP G400, G600, G800 and VSP F400, F600, F800: The command
ended abnormally because shared memory (Extension1) is not
added.
VSP G1000, G1500, and VSP F1500: The command ended
abnormally because shared memory (64KLDEV Extension) is not
added.
9724
All commands
VSP G200: The command ended abnormally because shared
memory (Base or greater) is not added.
VSP G400, G600, G800 and VSP F400, F600, F800: The command
ended abnormally because shared memory Base (Extension1 or
greater) is not added.
VSP G1000, G1500, and VSP F1500: The command ended
abnormally because shared memory Base (16KLDEV, SI, VM, DP,
TI, FC or greater) is not added.
9725
All commands
The command ended abnormally because the LDEV number of the
volume you specified as the HTI P-VOL is beyond the specified
range.
9726
All commands
The command ended abnormally because you specified an
unmounted volume as the HTI P-VOL.
9727
paircreate, pairsplit,
pairresync,
pairresync -restore
The command ended abnormally because you specified a blocked
volume as the HTI P-VOL.
CCI command reference for Thin Image
215
Hitachi Thin Image User Guide for Hitachi Virtual Storage Platform G Series and F Series