11-1
●
Emergency Procedures
11. EMERGENCY PROCEDURES
Press the main power switch to turn OFF the power.
●
If an earthquake, fire, or other emergency arises while the printer is
operating or when its power is on, turn OFF the power by pressing the
main power switch.
Never perform this procedure except in case of an emergency.
WARNING
●
Immediately after the emergency is cleared, press the main power switch to turn the power back
ON and press the Start up to initiate ink ejection.
●
If the emergency lasts for 5 minutes or longer, open the print head cover and clean the orifice plate
and its surrounding parts and gutter section by pouring makeup over them.
When resuming operation, thoroughly clean the orifice plate and its surrounding parts and gutter
section by pouring makeup over them, and then initiating ink ejection.
●
If the power supply is shut off by a power failure, perform the same procedure as indicated above.
In the event of a power failure
When you use the printer after power restoration, be sure to confirm the printings
and other setup data beforehand. If you find any incorrect printings or setup
data, correct it.
Note that the count update information for printing is not saved in memory.
When you use the printer after power restoration, it is necessary to set the count
update information (initial value data) again.
CAUTION
1
2
Main power switch
