3 Electrical and control settings
Unit electrical wiring and connection
SMGB0137 rev.0 - 05/2021
45
3
Follow the steps below to connect the earth wire to the earth connection in the electrical box:
1
Where necessary, loosen the screw on the earthing connection in the electrical box.
2 Connect the shielded part of the power supply earth wire and the signal wiring earth wire to the earth connection.
3
Tighten the screw on the earthing connection in the electrical box.
4
Check that the shielded part of the earthing cables are correctly secured.
Nº
Part
1
Electrical box
2
Tie
3
Die-cut wiring hole
4
Grille
5
Remote control wiring (optional)
6
Communication wiring
7
Power wiring
Remote control
(PC-ARFP1E)
Power supply wires
(single phase)
Transmission
wires
Earth screw
Cord clamps
Knockout hole
for wirings
Grille
Electrical box
Test runs
!
C A U T I O N
• Be careful during the test runs, as some of the safety functions remain disabled: the units operate for two hours without switching off
via the thermostat. The three-minute compressor protection is not enabled during the test.
•
Secure the rubber bushes to the panel using adhesive when the outdoor unit ducts are not used.
•
The compressor remains at a standstill during forced stoppage.
3.1.6 Electrical connection of RPI units
Work prior to the electrical connection
1
Turn off the power supply switches before starting work and fit the appropriate locks and safety warnings.
2
Wait 5 minutes after turning off the power supply switches.
3
Check that the fans on the indoor and outdoor units are at a standstill before starting work.
?
N O T E
• The electrical power for the unit must involve a specific power line, with an exclusive power control switch and residual current breaker,
installed in line with local or national safety regulations.
• Check that the electrical power line has enough capacity to supply the unit. Its length, the cable diameter and their protection (sleeve
or jacket) must be appropriate for the unit.
• For further information, always consider the current regulations in the country where the unit is to be installed.
!
C A U T I O N
• Risk of fire: cables must never touch the refrigerant pipes, printed circuit boards (PCB), sharp edges or electrical components inside
the unit to avoid damaging them.
• Loose connection terminals may lead to cable and terminal overheating. The unit may operate incorrectly, leading to a risk of fire.
Check that the cables are firmly secured to the connection terminals.
