Hitachi C 12LSH, Technical Data And Service Manual

Page: 11 / 101

--- 7 ---
(9) Positive angle stoppers
The Models C 12LSH and C 12RSH have positive angle stoppers
in the turn table at the right and the left of the 0 û center setting, at
15 û , 22.5 û , 31.6 û and 45 û settings.
Thanks to the positive angle stoppers, positioning can be done
more securely than the ball index method utilized in the current
Model C 12FSA. In addition, a lever is provided at the lower tip of
the turn table to secure or release the positive angle stoppers.
Adjustment of the turn table and positioning can be easily done
while holding the side handle.
Fig. 7
107 x 312
(4-3/16" x 12-1/4")
120 x 260
(4-11/16" x 10-3/16")
with aux. board width
25 mm (1")
(10) Slide cutting
* These numeric values are for the models destined for the U.S.A. and Canada.
Refer to "5. SPECIFICATIONS" as the capacities are different depending on the destinations.
Maker
Model
Max.
cutting
dimensions
HITACHI
C 12LSH
C 12RSH
Height x Width
(H x W)
Table 4 Unit: mm (inch)
HITACHI
C 12FSA
107 x 305
(4-3/16" x 12")
120 x 260
(4-11/16" x 10-3/16")
with aux. board width
20 mm (13/16")
C
98 x 310
(3-7/8" x 12-1/4")
120 x 230
(4-11/16"x 9")
with aux. board width
34 mm (1-5/16")
P
102 x 305
(4" x 12")
115 x 299
(4-1/2" x 11-3/4")
Workpieces as wide as shown in Table 4 can be cut with the motor head sliding. The lower limit position of the
saw blade is factory-adjusted so that workpieces up to 107 mm (4-3/16") high and 312 mm (12-1/4") wide can
be cut as shown in Fig. 9-a. When cutting a workpiece of 120 mm (4-11/16") in height as indicated in [ ] in
Table 4, adjust the saw so that there is a clearance of 2 to 3 mm (3/32" to 1/8") between the bottom surface of
the head and the top surface of the workpiece at the lower limit position of the saw blade as shown in Fig. 9-b.
(See the Instruction Manual, page 18 "4. Lower limit position of saw blade when cutting a large workpiece.")
Please note that when cutting in this position, it is necessary to use an auxiliary board of 25 mm (1") wide so
that the workpiece on the fence side can be cut full width.
Fig. 9-b Fig. 9-a
Fig. 8