--- 53 ---
11-3. Reassembly
Reassembly can be accomplished by following the disassembly procedures in reverse. However, special
attention should be given to the following items.
(4) When replacing the Laser Marker
[198A]
, screw the two Seal Lock Hex. Socket Set Screws M5 x 6
[200]
into
the Laser Marker
[198A]
. To adjust the accuracy of the Laser Marker
[198A]
easily, protrude the tips of the
two Seal Lock Hex. Socket Set Screws M5 x 6
[200]
about 1.5 mm from the Laser Marker
[198A]
using the
2.5-mm hex. bar wrench so that Holder (B)
[207]
and the Laser Marker
[198A]
become almost parallel as
shown in Fig. 66-a and Fig. 66-b. Refer to "11-10. Adjustment of Laser Marker Accuracy" for adjustment of the
laser marker accuracy.
Fig. 65
Back of the turn table
Fig. 66-a
(1) Prior to reassembly, measure the insulation
resistance of the armature, stator, switch and
other electrical components and confirm that the
insulation resistance of each part is more than
5 M
Ω
.
(2) When replacing the Spring
[152]
, apply 3 grams
of Hitachi Motor Grease to the inner
circumference of the new spring prior to
assembly.
(3) When replacing or reassembling the Liner
[98]
,
ensure it is positioned and assembled as
illustrated in Fig. 65. In addition, coat 10 grams
of Hitachi Motor Grease on the liner sliding
portion of the Turn Table
[26]
.
Fig. 66-b
Cross section viewed from the front
[198A]
[198A]
Summary of Contents for C 12LSH
