Hirschmann MACH 1020, User Manual

Page: 45 / 64

Installation MACH1000
Release 02 03/2013
45

10 Mbit/s F/O connection
10 MBit/s F/O ports (ST connectors) enable the connection of terminal
devices or independent network segments in compliance with the IEEE
802.3 10BASE-FL standard.

Full or half duplex mode
Default setting: Full duplex

100 Mbit/s F/O connection
100 MBit/s F/O ports (ST, DSC, MTRJ or SFP slot) enable the connection
of terminal devices or independent network segments in compliance with
the IEEE 802.3 100BASE-FX standard. These ports support:
 Full or half duplex mode
Default setting: Full duplex
Note: Make sure that the LH ports are only connected with LH ports, SM
ports are only connected with SM ports, and MM ports only with MM ports.

1 Gbit/s F/O connection
1 GBit/s F/O ports (SFP slot) enable the connection of terminal devices or
independent network segments in compliance with the IEEE 802.3-2000
(ISO/IEC 8802-3:2000) 1000BASE-SX or 1000BASE-LX standards.
These ports support:
 Autonegotiation
State on delivery: autonegotiation activated.
Note: Make sure that the LH ports are only connected with LH ports, SX
ports are only connected with SX ports, and LX ports only with LX ports.
Note: With the MACH 1030 with two Gbit/s F/O ports, these ports are
combo ports (SFP/RJ45). You can use either the SFP slot or the RJ45
socket to connect data lines. If both are used, the assigned SFP slot
switches off the related RJ45 port.
2.2 Display elements
After the operating voltage is set up, the software starts and initializes itself.
Afterwards, the device performs a self-test. During this process, various
LEDs light up. The process takes around 60 seconds.