Installation MACH1000
Release 02 03/2013
31
Figure 9: Power supply unit “G”
(see page 52 “General technical data”)
:
AC voltage (pictured above) or DC voltage (pictured below)
Connecting
1 - Supply voltage
2 - Signal contact
For
every
supply voltage to be connected, perform the following steps:
Ensure the required conditions for connecting the supply voltage are
observed
(see page 5 “Supply voltage”)
.
Connection Type “C”
Type “G” VDC
Type “G” VAC
, pin 1
Protective conductor
Protective conductor
Protective conductor
-/N, pin 2
Minus terminal of the supply
voltage
Minus terminal of the
supply voltage
Neutral conductor
+/L, pin 3
Plus terminal of the supply
voltage
Plus terminal of the
supply voltage
Line conductor
Table 7:
Pin assignment of spring-loaded terminal for voltage supply
WARNING
ELECTRIC SHOCK
Only start connecting the supply voltage if
all
the above mentioned
requirements are fulfilled.
(see page 5 “Supply voltage”)
Failure to follow these instructions can result in death, serious injury,
or equipment damage.
4 5
Relay
4 5
G
4 5
Relay
4 5
3
2
1
3
2
1
-/N +/L
3
2
1
3
2
1
-/N +/L
2
1
-
+
2
1
Summary of Contents for MACH 1020
Page 4: ...4 Installation MACH1000 Release 02 03 2013...
Page 61: ...Installation MACH1000 Release 02 03 2013 61...
Page 62: ...62 Installation MACH1000 Release 02 03 2013...
Page 64: ......
