6-
3
. Replacing the rail
Turn OFF the power switch before starting to replace and adjust
the rail.
The rail of this machine can be easily replaced.
If there is any dirt or flaw on the rail groove that prevents a smooth op
-
eration, we recommend the user clean or replace the rail.
Use the passing plate, rail and escaper that correspond to the diameter
of the screws loaded.
Remove any screws that were loaded in the chamber before doing any
replacing and adjusting.
Loosen the rail fixing bolts and pull out the rail assembly from the rear
of the machine. After replacing the rail, each part must be adjusted.
6-
4
. Replacing the Passing Plate
Turn OFF the power switch before starting to replace and adjust
the rail.
Use the passing plate, rail and escaper that correspond with the diam-
eter of the screws loaded.
*The following are passing plate numbers which correspond with the
model numbers:
1.0 - 1.7 corresponds with Model No. HS3-02052-1
2.0 - 3.0 corresponds with Model No. HS3-02052-2
Please check that the model numbers correspond with the screws
that can be used.
Remove the passing plate. Do not lose the attached bolts. Using bolts other than those supplied with this machine may re-
sult in a malfunction.
When installing, use the half-press on both sides of the passing plate as guides. After replacement, make the adjustments
that correspond with the screws loaded.
Loosen the rail fixing bolts and remove the rail assembly
from the rear of the machine.
Rail fixing bolt
Attaching bolt
Passing plate
Half-press
(Provided on each
side of the passing
plate.)
- 15 -