Remove the cover.
Disconnect the motor
connector.
Remove the motor
attaching screws.
M2.6 X 8 2 pieces
Remove the motor
attaching bracket
towards the rear.
Pull the motor out towards the rear.
main motor unit
- 13 -
6-
2
. Replacing the Main Motor
Turn OFF the power switch before starting to replace and ad-
just the main motor.
When the motor is damaged, replace it with a new one.
・
First, remove the cover from the main body. Then, disconnect the con-
nectors for the power switch and LED screw sensor.
This makes it easier to work within the body.
・
Disconnect the motor junction connector.
・
Remove the motor attaching screws on the bottom of the main body.
・
Pull out the motor from the rear side of the main body.
(If the motor is hard to pull out, insert an Allen wrench into the oblong
hole in the base of the body and push the motor attaching bracket
backward.)
・
The motor can be disassembled as shown in the figure on the right.
・
For reassembly, reverse the disassembling procedure.
The combination of the operation timing for the left and right scooping
blocks is shown on the next page.
Note:
→ Do not use excessive force with the motor wiring in order to
avoid wire breakage.
Part number of main motor unit: HSVRB-09105-15