Firmware recovery
46/75
Ø
On the netHOST Solutions DVD, open
Supplements & Examples
\netHOST Device Recovery\Recovery via Memory Card
directory.
Ø
In the directory, open the folder for your type of device, e. g.
NHST-
T100-DP_DPM
, then copy the
STARTUP.INI
file and the
BACKUP
folder
(with all its subfolders) to the root directory of the SD memory card.
Ø
Remove the SD memory card from the SD card reader device.
2. Copy load memory image to netHOST device.
Ø
Disconnect the voltage supply from your netHOST device.
Ø
Insert the SD card into the card slot of the netHOST device until it
engages (see position
(2)
in section
Positions of the LEDs, connectors
Ø
Reconnect the voltage supply of your netHOST device.
Ê
The device then loads the memory image. While loading the image, the
SYS LED quickly alternates between green and yellow for
approximately eight seconds, then shows steady yellow for
approximately ten seconds, then is switched off for a short while before
it finally shows steady green light. The device automatically starts the
loaded firmware.
Ø
Remove the SD memory card from device.
ð
The netHOST device has been reset to its factory settings.
The device now needs an IP address and a configuration.
netHOST NHST-T100 | LAN controlled master devices
DOC130401UM05EN | Revision 5 | English | 2018-05 | Released | Public
© Hilscher 2013 – 2018
