HIKVISION DS-K5671-3XF Series, User Manual

Page: 136 / 154

Configure Parameters for Access Control Device
After adding the access control device, you can configure its parameters, including overlaying user
information on picture, uploading pictures after capturing, saving captured pictures, etc.
Before You Start
Add access control device to the client.
Steps
1. Click Access Control → Advanced Function → Device Parameter .
Note
If you can not find Device Parameter in the Advanced Function list, hover the cursor on the
Advanced Function, and then Click to select the Device Parameter to be displayed.
2. Select an access device to show its parameters on the right page.
3. Turn the switch to ON to enable the corresponding functions.
Note
●
The displayed parameters may vary for different access control devices.
●
Some of the following parameters are not listed in the Basic Information page, click More to
edit the parameters.
RS-485 Comm. Redundancy
You should enable this function if you wire the RS-485 card reader to the access control
device redundantly.
Display Detected Face
Display face picture when authenticating.
Display Card Number
Display the card information when authenticating.
Display Person Information
Display the person information when authenticating.
Overlay Person Info. on Picture
Display the person information on the captured picture.
Voice Prompt
If you enable this function, the voice prompt is enabled in the device. You can hear the voice
prompt when operating in the device.
Upload Pic. After Linked Capture
Upload the pictures captured by linked camera to the system automatically.
Save Pic. After Linked Capture
If you enable this function, you can save the picture captured by linked camera to the device.
DS-K5671-3XF Series Face Recognition Terminal User Manual
122