© Hikvision
Enter the Time Settings interface:
Configuration > System > System Settings > Time Settings
Figure 6-43
Time Settings
Configuring Time Synchronization by NTP Server
Steps:
1.
Check the radio button to enable the NTP function.
2.
Configure the following settings:
Server Address: IP address of NTP server.
NTP Port: Port of NTP server.
Interval: The time interval between the two synchronizing actions by NTP server. It can be
set from 1 to 10080 minutes.
Figure 6-44
Time Sync by NTP Server
You can click
to make sure that the NTP server is connected.
Note:
If the camera is connected to a public network, you should use a NTP server that has a time
synchronization function, such as the server at the National Time Center (IP Address:
210.72.145.44). If the camera is set in a customized network, NTP software can be used to
establish a NTP server for time synchronization.
Configuring Time Synchronization Manually
Steps:
1.
Check the Manual Time Sync radio button.
2.
Click
to set the system time from the pop-up calendar.
3.
Click
to save the settings.
