© Hikvision
Note:
You need a FTP server and set FTP parameters first. Refer to Section 6.1.2 Configuring
FTP Settings for setting FTP parameters.
5.2.2
Configuring Video Tampering Alarm
Purpose:
You can configure the camera to trigger the alarm actions when the lens is covered.
Steps:
1.
Enter the Video Tampering settings interface :
Configuration > Event > Basic Event > Video Tampering
Figure 5-15
Tampering Alarm
2.
Check the checkbox to enable the tampering detection.
3.
Set the tampering area.
4.
Set Sensitivity level. Higher level means easier to trigger.
5.
Click
tab to enter the arming schedule setting interface. The arming
schedule configuration is the same as the setting of the arming schedule for motion detection.
Refer to Section 5.2.1 Configuring Motion Detection.
6.
Click
tab to select the linkage method taken for tampering. Notify
surveillance center, send email and trigger alarm output are selectable. Refer to Section 5.2.1
Configuring Motion Detection.
