Hettich BlueMax Mini Modular Plus, Operating Manual

Page: 45 / 88

45
2
1
2
1
3
1
Clean guide pins
1
.
Hole
2
in guide pin must be clean so clamping screw can hold
interchangeable drilling unit securely in place.
Fitting drilling unit
Fit the prepared interchangeable drilling unit by holding the
grip or by placing your hand below catch
2
.
Make sure guide pin goes in straight.
Move interchangeable drilling unit up and engage safety
catch
1
.
Tighten star shaped grips
3
.
Checking switch for proper working order
The 6 spindle interchangeable drilling unit is used for drilling
holes and for inserting a hinge / connector.
The drilling unit's drive system must be switched off for
inserting the hinge / connector.
Using the hand lever
2
, turn press in frame
2
into the
inserting position. Operate switch
1
with the lever and turn
motor off using the switch. Check for proper working order.
Adjust the switch if necessary.
Switch
1
must always be checked for proper working order
after changing the drilling unit or after the machine has been
out of service for a prolonged period.
Fig. 40: Interchangeable drilling unit, 9 spindles
Fig. 41: Changing interchangeable drilling units
Fig. 42: Changing interchangeable drilling units
Fig. 43: Cleaning interchangeable drilling unit
Fig. 44: Guide pin
Fig. 45: Fitting drilling unit
Fig. 46: Star shaped grips
Fig. 47: Switch