Hettich BlueMax Mini Modular Plus, Operating Manual

Page: 38 / 88

38
7. Setting up
1. Preparing machine 38
Readiness for use 38
Connecting to extractor system 38
Connecting to compressed air supply 39
Connecting to power supply 39
Switching 40
Operating 40
Drilling hole line, interchangeable drilling unit,
9 spindles 41
Inserting hinges 42
2. Setting up (preparing for work) 42
Tools used (drill bits) 42
Interchangeable drilling unit, 6 spindles,
Interchangeable drilling unit, 3 spindles,
(Selekta 22/9) 43
Interchangeable drilling unit, 9 spindles 43
Interchangeable drilling unit, 90°, 9 spindles 44
Changing interchangeable drilling units 44
Cleaning 44
Fitting drilling units 45
Checking switch for proper working order 45
Setting drilling depth, vertical drilling unit 46
Drilling with horizontal drilling unit 46
Settings on the back of the machine 47
Limiting drilling stroke for drilling hole lines 48
3. Hold-down clamps and centre stop 48
Hold-down clamp 48
Centre stop 49
Setting the drum stops 49
1. Preparing machine
The BlueMax Mini Modular Plus is shipped in cardboard
packaging. A number of parts and components must be installed
to make the machine ready for operation. Once assembled, the
machine must be thoroughly cleaned (removal of dust and any
oil or grease)
Before switching the automatic drilling and insertion machine
on, satisfy yourself that
• any installation, set up and servicing work has been
completed in full
• no persons are present in the danger zone, let alone
working on it
• all safety guards are fitted in the prescribed way
• the compressed air supply is ready for operation
Before commencing production:
• Make sure the machine is safe and in proper working order
before and after you switch it on
• Make sure the compressed air supply is ready for operation
• Make sure the machine has been set up for the relevant
product
Readiness for use
The machine is ready for operation if
• All of the above stated activation processes have been
carried out
• A trial run has been carried out
• The compressed air supply is activated
• The machine is set up for the relevant product
• The machine is firmly mounted on a bench / base frame
Production can now commence
Connecting to extractor system
Connect the machine to an extractor system. It is compulsory
to use flexible, fire-retardant hose for connection to an
extractor system.
Fit the extractor system's extraction hose to suction
connector
1
and secure this in place with a hose clamp.
The extractor system must have an airflow rate of at least 20 m/s.
Extraction hose diameter: Ø 80 mm. Route extraction hose so as
not to exert strain on the suction connector!
Fig. 22: Suction extraction connector
Setting up
1