Hettich BlueMax Mini Modular Plus, Operating Manual

Page: 25 / 88

25
15. Safety guards to be provided by the owner
Safety guards provided by the owner must be easily accessible
and in full working order after installing the machine. They
must not interfere with the machine's own safety guards in
operation on site.
The site of installation must be selected in such a way that
will also allow repairs to be performed at a later date without
physical obstruction.
16. Permissible ambient conditions
• The machine must only be installed and operated in dry
rooms
• The machine is not explosion-protected. The machine must
not be installed near painting facilities
• Provide a supply of fresh air to the fan cowls on electric
motors
• Avoid any external mechanical strain on the machine
17. Removing preservatives
The machine is only coated with preservatives for
transportation.
•
Clean dust and shipping dirt from the machine with a dry
cloth.
• Never use cold-cleaning products, nitrocellulose thinners or
other aggressive chemicals!
• Remove all transport braces. These should be kept for later
reuse
18. Electrics
The automatic drilling and insertion machine is fitted with a
connection cable and a 16 amp plug. The power socket must
be checked for proper working order by a qualified electrician.
You will find the applicable connection specifications on the
rating plate on the machine.
Requirements on the electrical power supply
Connection must only be made to an electrical system
complying with VDE 0100. The electrical safety of this
equipment is only guaranteed if it is connected to a protective
earth conductor system that complies with regulations. It is
very important to check that this basic safety requirement
is met and that the machine is provided with adequate fuse
protection. The manufacturer cannot be held responsible for
damage cause by a lacking or interrupted protective earth
conductor. The rating plate provides information on rated
input and the appropriate fuse protection.
19. Compressed air connection
The automatic drilling and insertion machine has a fitted
coupler plug, nominal width 7.2
• Max. input pressure 8 bar / 100 psi
20. Suction extractor
It is compulsory to use a flexible, fire-retardant hose for
connection to an extractor system. A suction extraction line is
not included.
• Outside diameter (suction connector)
80 mm
• Air flow rate min. 20 m/s
NOTE
For further technical specifications, refer to the
documentation provided by the manufacturers.
Unauthorised changes and modifications to the system
are not permitted for safety reasons and rule out
any liability on the part of the manufacturer for any
resultant damage.