Servicing the device
60
Pull out the flash tube (3).
If necessary, remove all glass fragments of the flash tube.
Remove the new flash tube from the packaging.
Make sure the glass body of the new flash tube is not defective.
Place the flash tube on the base and carefully push the flash tube into
the device up to the limit stop.
Pull out the flash tube by approx. 0.5 mm again so that the glass body
can expand when heating up.
Wrap the trigger wire (2) around the connection pin (1) on the device
and bend it towards the glass body of the flash tube.
If the remaining trigger wire (2) is too long, shorten it with pliers.
Make sure the trigger wire (2) is correctly wrapped around the
connection pin (1).
Summary of Contents for FORIS 1000
Page 72: ......
