Operating the device
50
Activating and deactivating the LED model light (Lamp
Boost)
To activate the “Lamp Boost” LED model light, proceed as follows:
Briefly press the rotary switch once.
The model light is switched to double energy for 30 seconds.
To deactivate the “Lamp Boost” LED model light, proceed as follows:
Briefly press the rotary switch once again.
The “Lamp Boost” LED model light is deactivated.
Synchronizing the device with the camera
The device and the camera are synchronized using the following
components:
Sync cord
Built-in photo cell
Built-in radio receiver
Synchronizing the device using the cable
To connect the device to the camera, proceed as follows:
Insert the jack plug of the sync cord into the sync socket of the device.
Connect the other end of the sync cord to the camera. Observe the user
manual of the camera.
Activating and deactivating the photo cell
The flash is triggered through the photo cell by the striking of a flash
emitted by another device. The photo cell functions as a pulse photo
cell. It works only if the light output of the emitted flash is stronger
than the available light. For this reason, you must ensure that
excessively strong extraneous light does not affect the photo cell. In
such cases, the flash must be triggered either using the sync cord or
the radio remote trigger.
Summary of Contents for FORIS 1000
Page 72: ......
