Henny Penny PFE-591, Operator'S Manual

Page: 58 / 73

Model PFE- 591
3-16. SPECIAL PROGRAM Manager Code Change (SP-15)
MODE (Continued) This allows the operator to change the program code, or manager
code (factory set at 1, 2, 3) used to access Product
Programming, Special Programming, Clock Set, Data Comm,
and Heat Control Modes.
a. Follows steps 1 and 2 above.
b.Press until “SP-15” and “CHANGE, MGR CODE?
1=YES” shows in display, along with “CODE”.
c. Press . “ENTER NEW CODE, P=DONE, I=QUIT”
shows in display. Press Product buttons with new code.
d.If satisfied with code, press . “REPEAT NEW
CODE, P=DONE, I=QUIT, shows in display. Press same
code buttons in step c.
e. If satisfied with code, press . *CODE CHANGE*
shows in display.
f. If not satisfied with code, press and “*CANCELLED*”
shows in display, then reverts back to “SP-15” and
“CHANGE, MGR CODE, 1=YES”. Then the above steps
can be repeated.
Usage Code Change (SP-16)
This allows the operator to change the usage code(factory set at
1, 2, 3) used to reset the usage data in the Information Mode.
a. Follows steps 1 and 2 above.
b.Press until “SP-16” and “CHANGE, USG CODE?
1=YES” shows in display, along with “CODE”.
c. Press . “ENTER NEW CODE, P=DONE, I=QUIT”
shows in display. Press Product buttons with new code.
d.If satisfied with code, press . “REPEAT NEW
CODE, P=DONE, I=QUIT, shows in display. Press same
code buttons in step c.
e. If satisfied with code, press . “*CODE CHANGE*”
shows in display.
f. If not satisfied with code, press and “*CANCELLED*”
shows in display, then reverts back to “SP-16” and
“CHANGE, USG CODE, 1=YES”. Then the above steps
can be repeated.
3-42 403