Model CFE-415, 427
20
March 2016
3-5
FILLING OIL RESERVOIR
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
1.
During morning start-up procedures when control displays “FILL
RESERVE OIL” or when control displays “E-1” and an alarm
sounds, fill the auto-fill oil reservoir.
2.
Pull reservoir forward and open reservoir cover. See Figure 1.
3.
Pour oil into reservoir, then close cover and push reservoir back into
position. See Figure 2.
Removing/Cleaning Reservoir
1.
Pull reservoir forward until it stops.
2.
Lift-up on reservoir, disengaging the reservoir from the slotted key-
way. Figure 3.
3.
Clean reservoir at a sink with soap and water.
Reinstalling the Reservoir
1.
Place the oil reservoir onto the shelf. Be sure to align the studs on the
bottom of the reservoir to the slots in the shelf. See Figure 3.
2.
Push the reservoir back until it the tube is aligned with the receiver.
See Figure 4.
3.
Push the reservoir into the receiver until it is fully engaged (all 3
o-rings are inserted into the receiver). See Figure 5.
Before placing the reservoir back into position, lubricate the o-rings
(below) on the filter tube with cold oil. Check o-rings for tears or nicks
and replace if necessary. To replace o-ring, use a small, flat-bladed
screwdriver, pry up on the o-ring and pull off of end of tube. See below.
Summary of Contents for CFE-415
Page 2: ......
Page 12: ...Model CFE 415 427 8 Feb 2016 2 7 DIMENSIONS CFE 415...
Page 13: ...Model CFE 415 427 9 Feb 2016 2 7 DIMENSIONS CONT CFE 427...
Page 81: ......