This option adds IF switching capability to allow up to four test sets to be connected to the HP8510B at
the same time. The test set in use is selected from the HP85108 front panel. The 20 MHz IF signal is
transmitted from the standard test set through the option 001 test set(s) to the network analyzer. IF
switching is performed automatically by the option 001 test set(s), without reconnections.
This option deletes the 90
programmable step attenuators and the dc bias tees. Note that bias can
be applied externally, using the
bias tee, if bias is required but attenuation not.
This high forward dynamic range configuration is described in detail in this section under the title
Description and Operating Characteristics of the Instrument.
This option is a combination of option 002 and option 003, which were previously described.
This option supplies the test set with the parts required to rack mount it with handles removed. Refer to
the
section of this manual for additional information.
This option provides a duplicate test set manual.
This option supplies the test set with the parts required to rack mount it with handles. Refer to the
INSTALLATION section of this manual for additional information.
Option W03 converts the standard one year return to Hewlett-Packard warranty to a 90 day on-site
warranty. W03 can only be ordered at the time of instrument purchase. Instruments ordered with option
W03 are identified on the serial number label, or on a special identification label supplied with the
instrument.
Option
adds two additional years of return-to-HP service, to follow the first year of warranty.
Option
can be ordered only at the time of purchase. Instruments ordered with option
are
identified on the serial number label, or on a special identification label supplied with the instrument.
NOTE: additional system warranty information is included in the HP8510 manual set.
1-4 General Information
HP
Test Sets