5 Configuring the Governor with the Hand Held Programmer
Programmer PG 02
27
5.2.3.4
Data TransferPC
→
Hand Held Programmerr
→
PC
Similary, the data set of the hand held programmer may be downloaded to a PC. Vice
versa, the hand held programmer may be programmed with a data set from the PC.
Connecting the hand held programmer and a PC will require a special adapter cable
that ensures power supply to the hand held programmer. To put the hand held
programmer into communication mode, it is necessary to keep either the
[SEND DATA] key or the [GET DATA] key pressed for about 5 seconds while the
hand held programmer is connected to the power supply. After issuing the switch-on
message, the display reads "Waiting for a command", signalling that the hand held
programmer is ready for communication with the PC. In addition, the hardware and
software numbers of the data set stored are displayed. Using the HEINZMANN
®
PC
program DC_DESK, the data set stored in the hand held programmer can now be
read out and stored in the PC. Storage is commented by the hand held programmer
with the message "Transmitting data".
In similar fashion, data can be downloaded from the PC to the hand held
programmer. In this case, transmission is no longer confined to complete data blocks
but will equally work for a restricted choice of parameters (see description of PC
program). Receipt of data sets by the hand held programmer is acknowledged
through the message "Receiving data".
5.2.3.5
Error Memory
For more detailed information about the error memory, please refer to later chapters
of this manual. At this point, it will suffice to explain the functions of each single
key.
7
CLEAR ERR
This key serves to clear the error memory of actual errors. The display will
show the message "Clear error memory".
9
ERASE ERR
With this key, the errors saved permanently in the governor are erased. The
action is confirmed by the message "Erasing errors".
5.2.3.6
Data Blocks
The governor is capable of accomodating several data blocks each containing a
complete data set.
8
ERASE BLK
On pressing this key, the existing data sets are listed, and the number of the
data block to be deleted can be entered. Entry may be aborted with the key [CE]
without deleting any data sets.
