5 Configuring the Governor with the Hand Held Programmer
Programmer PG 02
21
The hand held programmer is supplied power through the governor's
communication interface so there will be no need for any additional supply by
batteries or the like. Similarly, data transfer between the Hand Held Programmer
and a PC will require using a special adapter cable to ensure current supply to
the Hand Held Programmer.
5.1
The Display Panel
Parameter number
SPEED_PICK_UP1
2001 1230 1/min
ERR_ACTUATOR_DIFF
0÷4095 on
Unit
Value
Parameter name
Value range
Current error
User mask
Figure 2: The Display Panel
Figure 2 shows the display panel with a standard parameter representation. The parameter
currently selected is the actual speed value as measured by speed pickup 1. This
measurement has been assigned the parameter number 2001 and the parameter name
SPEED_PICK_UP1. Current speed is 1230 revolutions per minute (1/min), the total value
range being from 0 through 4095 1/min. The small field for the user mask indicates,
whether the parameter specified has been programmed for inclusion in the user mask (see
section 3.5). This label can read three states:
on
The parameter specified has been programmed for the user mask. The user
mask, however, is not activated.
off
The parameter specified has not been programmed for the user mask. The user
mask is not activated.
MASK
The parameter specified has been programmed for the user mask. The user
mask has been activated.
The bottom line displays messages about current errors. In the above example, the error
"Excessive difference in actuator travel" is signalled to have occurred. If no error is being
detected, the message NO ERROR will show up.
Note
