Heinzmann Programmer 2, Manual

Page: 13 / 57

2 General
Programmer PG 02
7
The following overview table shows where the individual parameters are to find.
A detailed parameter list, with which each individual parameter is described, is at the end
of the respective manual with the appropriate software description.
Parameters Measurements Functions Curves
No. Designation No. Designation No. Designation No. Designation
1 Number of Teeth,
Speed
2000 Speed Pickup,
Speed
4000 Speed Pickup,
Speed
6000
100 Stability,
Droop
2100 Stability,
Droop
4100 Stability Map,
Droop
6100 Stability Map
200 Ramp,
Start
2200 4200 Ramp 6200 Stability Map
(Correction Values)
300 Actuator Travel 2300 Actuator Travel 4300 6300
400 CAN 2400 CAN 4400 CAN 6400 Boost Pressure dependent
Fuel and Load Limitation
500 Oil Pressure, Boost
Pressure, Temperature
2500 4500 Oil Pressure, Boost
Pressure, Temperatuer
6500 Oil Pressure Monitoring
600 Excitation Control 2600 Excitation Control 4600 Excitation Control 6600 Excitation Control
700 Limitations 2700 Limitations 4700 Limitations 6700 Speed dependent
Fuel Limitation 1
800 Switch Functions,
Digital Outputs
2800 Switch Functions,
Digital Outputs
4800 Digital Inputs,
Digital Outputs
6800 Speed dependent
Fuel Limitation 2
900 Setpoint Adjusters,
Sensors
2900 Setpoint Adjusters
Sensors
4900 Setpoint Adjusters,
Sensors
6900 Speed Notches
Speed dependent Load
Limitation
1000 Error Handling 3000 Current Errors 5000 Error Handling 7000
1100 3100 Error Memroy 5100 Error Handling 7100
1200 Generator 3200 5200 Generator 7200 Pump Map
5250 Marine
1350 Locomotive 3350 Locomotive 5350 Locomotive 7300
1500 Analogue Inputs 3500 PWM-Inputs,
Analogue Inputs
5500 Channel Type 7500
1600 PWM-Outputs
Analogue Outputs
3600 5600 Analogue Outputs 7600
1700 Positioner 3700 5700 Positioner 7700
1800 Status 3800 Status 5800 7800
1900 Servo Loop,
Feedback
3900 Servo Circuit,
Feedback
5900 Servo Loop,
Feedback
7900 Temperature Sensors
Feedback
Table 1: Parameter Overview