HEIDENHAIN TNC 320, User Manual

Page: 564 / 581

Tables and overviews
17.5 Functions of the TNC 320 and the iTNC 530 compared
17
564
TNC 320 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014
Cycle TNC 320 iTNC 530
410, datum from inside of rectangle X X
411, datum from outside of rectangle X X
412, datum from inside of circle X X
413, datum from outside of circle X X
414, datum at outside corner X X
415, datum at inside corner X X
416, datum at circle center X X
417, datum in touch probe axis X X
418, datum at center of 4 holes X X
419, datum in one axis X X
420, measuring an angle X X
421, measuring a hole X X
422, measuring a circle from outside X X
423, measuring a rectangle from inside X X
424, measuring a rectangle from outside X X
425, measuring inside width X X
426, measuring a ridge from outside X X
427, boring X X
430, measuring a bolt hole circle X X
431, measuring a plane X X
440, measuring an axis shift – X
441, Rapid probing (on TNC 320 partly possible with touch probe
table)
– X
450, saving the kinematics – X, option 48
451, measuring the kinematics – X, option 48
452, preset compensation – X, option 48
460, calibrating a TS on a sphere X X
461, calibrate TS length X X
462, calibration in a ring X X
463, calibration on stud X X
480, calibrating a TT X X
481, measuring/inspecting the tool length X X
482, measuring/inspecting the tool radius X X
483, measuring/inspecting the tool length and radius X X
484, calibrating the infrared TT X X