17 / 68
CS
EN
SK
PL
HU
note: In case of doubt, check with your electricity supplier or with your electrician
if your home connection meets these requirements.
•
Place the power cord so that it will not interfere with work and to avoid damage.
•
Keep cord from heat, corrosive liquids and sharp edges.
•
When disconnecting the power plug do not pull the cord.
•
If the service cabel is damaged, let it have changed in accredited service to prevent the danger
•
Do not carry or manipulate the machine by service cabel, do not pull up the socket inlet from the socket
outlet by pulling the service cabel. Protect the service cable against heat, grease and sharp edges.
UNPACKING
•
Carefully remove the product from the box.
•
Carefully inspect all parts. If any part is damaged or missing, contact your dealer or authorized
service center.
•
Do not throw away packaging materials until you have not reviewed carefully if they did not
remain a part of the product.
•
Parts of the packaging (plastic bags, paper clips, etc.) do not leave within reach of children,
could be a possible source of danger. Do not let children play with plastic bags, foils or small
parts. There is a danger of swallowing or suffocating!
•
Disposal must be made in accordance with the regulations in force in the country in which the
equipment was installed.
•
Make sure that bags and containers of plastic material are left strewn freely in the environment
because they pollute it.
•
If you have any doubt do not use the machine, but have it checked by an authorized service
center.
PACKAGE CONTENTS
the body of the machine, collecting box , 2x Support foot, push stick
Standard accessories are subject to change without notice.
This product requires assembly. The device must be assembled correctly before use.
If you notice transport damage or while unpacking, notify your supplier immediately. Do not
operate the machine! We recommend save the package for future use. The packaging materials
must still be recycled or disposed of in compliance with the relevant legislation. Sort different
parts of the packaging according to material and hand it to the appropriate collection sites. For
further information contact your local administration.
ASSEMBLY
ASSEMBLY OF THE SHREDDER
1. Turn the shredder upside down and pivot the legs up ward. (Fig. 1)
2. Pleace the supplied wheel axle (A) through the respective openings. (Fig. 1)
3. Put the supplied washer (B) adn sleeve (C) onto the wheel axle. (Fig. 2)
4. Please the wheels (D) and install nut hand tight (E). (Fig. 3)
5. Using the supplied hex wrench (F) to fix the wheel acle and at the same time firmly lock the
nut by using the wrench (G). (Fig. 4)
