18 / 68
CS
EN
SK
PL
HU
6. Finally, plece the wheel cover (H) in the center of the wheel. (Fig. 5)
aTTEnTIOn : Take care when tiling the unit onto its wheels as the unit has an
uneven weight distribution when tilted and during wheeled transportation.
INSTALL COLLECTION BOX
1. Press down the lock button (A) and then insert the collection box into the undercarriage. (Fig.6)
2. Press the lock button upward
OPERATION
COMMISSIONING
Ensure that the mains voltage agreed with the data on the nameplate.
Use an extension cord to connect your device (extension cord is not included).
ON/OFF
WaRnInG! Make sure that mains voltage corrensponds with data on the type plate .
Filling funnel must be empty.
1. (3) connect the extension cable.
2. Place the rotation direction switch (11) to “indraft“position.
3. To turn on press ON button (10).
4. To turn off press OFF button (10.
ROTATION DIRECTION ADJUSTMENT
Before changing the direction of rotation, always switch off the machine and wait until
the crushing roller stops completely.
“Indraft“ position
Place the rotation direction switch to “indraft“ position (continuous operation): material is
pulled in and shredded.
“Reverse“ position
Place the rotation direction switch to “reverse“ position (tap operation): blocked shredded
material will be released.
DEBRIS BAG DISCHARGE
Empty debris bag in time. Bare in mind that the debris bag under discharge channel is
filled unevenly!
1. Switch off the machine.
2. Unlock the debris bag with safety switch (see 6/A) in „OFF“ position.
3. Pull debris bag out from the chassis and empty it.
4. Before sliding debris bag back onto the chassis, make sure that there are no wood chippings
around the safety switch.
5. Slide the debris bag onto the chassis and put the safety switch back to „ON“ position.
OVERLOADING PROTECTION
The device automatically switches off when the engine is overloaded, e.g. blocked roller with
thick branches.
