50
Heat & Glo • LUX36, LUX42 Installation Manual
• 2287-980 Rev. L
• 2287-980 Rev. L • 4/16
F. Burner Tube Removal
• Disconnect power to appliance.
• Remove media from appliance.
• Remove the “L” plates and inner surround frame.
Note:
Mark and note burner tube locations. They are not
interchangeable. See Figure 11.16.
• Remove decorative steel log assembly by removing 3
screws, lifting up and out. See Figure 11.19.
• Remove center burner tube by removing two screws.
See Figure 11.20.
• Remove three outside burner tubes by removing two
screws on each tube. It will be necessary to remove
two screws from the pilot assembly and two screws
from the pilot shield on the rear burner tube prior to
removal. See Figure 11.18
• Remove three cover plates by removing two screws
from each plate. See Figure 11.17.
Figure 11.16 Burner Tube Identi
fi
cation
Figure 11.17 Remove Three Plates
Figure 11.18 Remove Outside Burner Tubes
Figure 11.19 Remove Decorative Steel Log Assembly
Figure 11.20 Remove Center Burner Tube
• Adjust shutter settings as required.
• Reverse removal procedure to reinstall burner tubes
and log assembly.
