45
Heat & Glo • LUX36, LUX42 Installation Manual
•
• 2287-980 Rev. L
2287-980 Rev. L • 4/16
Non-Combustible Zone
Figure 10.11 Non-Combustible Zone
E. Decorative Fronts
A decorative front is required for this appliance. Only dec-
orative fronts certi
fi
ed for use with this appliance model
may be used. The following decorative fronts are ap-
proved:
• FS-36-XX
• LMOD-36XX
• FS-42-XX
• LMOD-42XX
(X = color choice)
Decorative front
fi
nishing templates designed for use with
the LMOD Series decorative fronts are included with this
appliance. Decorative front
fi
nishing templates for the FS
Series decorative fronts may be ordered separately from
Hearth & Home Technologies dealers. See below.
A
B
COMBUSTIBLE MATERIAL
NON-COMBUSTIBLE
BOARD
DECORATIVE
FRONT TYPE
A
B
FS
3/4 IN.
1-1/4 IN.
LMOD
1 IN.
3-1/4 IN.
Figure 10.12 Required Clearance for Inside Fit Decorative Fronts
The decorative fronts approved for use with this appli-
ance have been designed to be installed by two methods:
Overlap Fit or Inside Fit. Before beginning the installation,
it is important to determine which method will be used.
Overlap Fit Decorative Fronts:
These decorative fronts
have been designed to be installed over
fi
nishing material
that is less than one inch thick.
Inside Fit Decorative Fronts:
These decorative fronts
may be recessed into non-combustible
fi
nishing material
up to 4 inches thick.
NOTICE:
Proper clearances from the
fi
replace opening to
fi
nishing material thicker than 1 inch MUST be maintained
when installing appliance in an inside
fi
t application. See
Figure 10.12.
DECORATIVE
FRONT
TOP
PART#
QTY
SIDE
PART#
QTY
FS-36
2280-331
1
2280-330
2
FS-42
2281-331
1
2281-330
2
NOTE:
Finishing templates are included with this product.
See Section 10.A.
NO COMBUSTIBLES
IN HATCHED AREA
1/2 IN. BUILDING MATERIAL
(MAY BE COMBUSTIBLE)
FACTORY-SUPPLIED
1/2 IN.
NON-COMBUSTIBLE
BOARD
PIPE IS FOR VISUAL
REFERENCE ONLY
1 IN.
= COMBUSTIBLES
NOT ALLOWED
2 X 4 OR GREATER
FRAMING MATERIAL
NOTE:
2 X 4 HEADER
CONFIGURATION
2 X 4 ONLY IN
GRAY AREA
3 IN.
