29
Heat & Glo • LUX36, LUX42 Installation Manual
•
• 2287-980 Rev. L
2287-980 Rev. L • 4/16
A. Vent Collar Preparation
6
6
Appliance Preparation
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
NOTICE:
This appliance is top vented ONLY.
1. Remove shrink wrap from appliance. Figure 6.1 shows
the shipping location of the seal cap and heat shields
(Section 6),
fi
nishing templates (Section 10), and the
glass refractory and media (Section 11).
2. Remove seal cap from top of appliance by removing
one screw, which is included, to prevent construction
material from getting into appliance. Remove seal cap
when pipe installation phase begins. See Figure 6.2.
3. Ensure gasket seal is in place prior to installing vent
pipe sections. Gasket is installed at the factory.
SEAL CAP
SEAL CAP
GASKET
GASKET
Figure 6.2 Seal Cap and Gasket Location
SEAL CAP
SEAL CAP
FINISHING
FINISHING
TEMPLATES
TEMPLATES
(NOT SHOWN)
(NOT SHOWN)
HEAT SHIELDS
HEAT SHIELDS
MEDIA
MEDIA
GLASS REFRACTORY
GLASS REFRACTORY
NON-COMBUSTIBLE BOARD
NON-COMBUSTIBLE BOARD
Figure 6.1 Shipping Location of Components
