Hawkeye Mfg RG1300, Installation Manual

Page: 25 / 60

4
016-0171-655 Rev. E 21
NOZZLE CONTROL VALVE INSTALLATION
4. Thread the ProStop-E adapter (P/N 063-0173-964) to the Wilger nozzle body.
FIGURE 4. ProStop-E Adapter Installation Location
5. Attach the Wilger nozzle body to the boom.
6. Install the Hawkeye
®
NCV to the Wilger drop closest to the wet boom tube.
7. Using the U-clip, install the ProStop-E to the previously installed adapter. Ensure the flat surface on the U-clip is
towards the ProStop-E body (tabs down).
SPECIAL INSTALLATION INSTRUCTIONS
1. In the areas of the center rack and the first three nozzle bodies of the primary boom where the wet pipe is
offset behind the boom way inlet use the modified nozzle assembly. The assembly requires the Wilger nozzle
body 2-way inlet (P/N 333-0002-332), the Wilger adapter plug (P/N 333-0002-319), and Wilger end body (P/N
333-0002-325).
FIGURE 5. Completed Wilger Assembly