Hatteland HD 15T22 MMD-xxx-F series, User Manual

Page: 66 / 156

66 User Controls
OSD Menu Functions
IND100064-55
Management Settings
Allows you to adjust overall settings for interaction/communication for the unit, such as scaling, zoom,
timing of signals, sensitivity for the touch control, VGA filter and Serial/Ethernet communication and more.
The contents of these submenus are listed below.
|---2---
Management Settings - Graphic Scaling *Available in "Advanced" only
Allow to scale the currently displayed full screen signal in various ways. The contents of the
submenus is listed below.
|--------3--------
Management Settings - Graphic Scaling - Graphic Scaling
All scaling will performed from center of active display area and outwards in all directions.
Settings as follows:
"Full Screen" = Zoom current full screen signal to fill the entire active display
area. Aspect ratio is ignored, which means that picture may
appear distorted or stretched.
"Fill to Aspect Ratio" = Zoom current full screen signal to fill the entire active display
area and preserve the aspect ratio. This means that you may
notice black bars without any image information either on
top/bottom or left/right of the centered image.
"One To One" = Zoom current full screen signal to fill the entire active display
area as 1:1 native pixel resolution. Example; if the incoming
signal is a 800x600, on a 1600x1200 unit, the incoming
signal will be shown 50% less in size and centered on
screen. Aspect ratio is kept unchanged.
|--------3--------
Management Settings - Scaling - Zoom
All zooming will performed from center of active display area and outwards in all directions.
Settings as follows:
"Zoom" = Zoom the current full screen signal horizontally and vertically
in equal steps. Values from 0 to 100.
● Note: Values under or over 50, may cause blurry and unfocused imagery, since it overrides the
external signal’s 1.1 pixel information and properties. Factory Default value is 50.