15
Install Kit 4485B
Install spray shield (001-4424B) on baler as shown in Figure 1 and 2. Use the two existing holes shown in
Figure 1 and one existing hole shown in Figure 2 to attach the spray shield.
Install Kit 4502B
The shield for your baler will mount in the throat of the baler as shown above. Remove nut and bolt on both
sides of baler. (Figure 1). Install shield holders (001-
4703I) with 1/2 x 2” bolts, nuts, locks and flat washers.
Do not tighten these bolts until the shield is properly aimed. Aim the shield at bottom of the pickup head at the
point where stuffer fingers connect with hay (between the two augers) and make sure the bushing is not
removed. Once the shield is in place the nuts may be tightened down.
Figure 1
Figure 2
Figure 1