10
Installation of Drain Fill Kit (Models 444T, 450T & 451T)
Model 444T
Using parts bag 1, locate the pre-drilled hole at the front of the bale chamber (figure 1). Secure valve assembly
to baler using 5/16” x 3/4” carriage bolts (figure 2). Thread 3/4” elbow fitting into tank, cut hose to correct
length and connect to valve assembly. Secure with hose clamps on both ends (figure 3).
Model 450T
Locate parts bag 1. Install the straight fitting (003-A3434) or elbow fitting (003-EL3434) into the side fitting in
the tank
(Figure B). Drill two 5/16” holes using the valve holder (001-6702H) as a template on the right side of
the baler above the tire. Mount the valve holder with two 5/16” x 1” self-tapping bolts and flange nuts. Attach
the 3/4” cam coupler to the 3/4” ball valve through the valve holder. Insert the straight fitting (003-A3434) into
the ball valve. Cut the 3/4” hose to length secure on both sides using hose clamps. Install supplied safety
decals (DCL-8001 & DCL-8005) next to the ball valve assembly.
Model 451T
Locate parts bag 1. Thread 3/4" elbow fitting into end of tank. (003-EL3434)
Run 3/4" hose from the elbow
down the frame to the bottom of the baler. Drill 1/4" holes to accept the valve holder bracket and use 5/16” x1”
self-tapping screws and flange nuts. Connect valve assembly to other end of hose. Place hose clamps on both
ends. Secure hose to frame using zip ties
.
Install supplied safety decals (DCL-8001 & DCL-8005) next to the
ball valve assembly.
Figure 1
Figure 2
Figure 3