![background image](http://html1.mh-extra.com/html/harvest-tec/444t/444t_installation-manual_2103710011.webp)
11
Placement of Spray Nozzle Assembly
Install Kit 4409B
1. Mount the left hand nozzle strap (it has an
elbow fitting and a silver tip) so that it is
approximately 80% across the width of the
pick-
up head. Example: if the head is 60”
wide, locate the nozzle 48” from the right
side of the head (60”x80”.)
2. Mount the right hand nozzle strap (it has a
tee fitting and a silver tip) so that it is
approximately centered on the pickup head.
3. Place the two auxiliary nozzle straps in
between the first two straps.
4. Bend the nozzle bar in so that the tip is
pointed in toward the bottom of the gathering
chamber and about 16” above the sheet
metal base of the chamber. Twist the nozzle
so the tip is tilted 45 degrees from
horizontal.
5. Three 1/4 inch lines will need to be run from
the hose manifold to the nozzle straps. Use
the color-coded stickers to attach the correct
hose to the correct tips, and couplers.
Secure the lines to the bracket and spray
shield using the supplied hose clamps.
Install Kit 4410B
Install Hoses before installation of shield.
Bolt the nozzle holder (A) up under the baler’s hood.
Remove 3 bolts (B) on the baler and replace with hardware in kit to fasten lip(C) securely in place.
Three 1/4 inch lines will need to be run from the hose manifold to the spray shield. Use the color-
coded stickers to attach the correct hose to the correct tips, and couplers. Secure the lines to the
bracket and spray shield using the supplied hose clamps.